Cookies on this website

We use cookies to ensure that we give you the best experience on our website. If you click 'Accept all cookies' we'll assume that you are happy to receive all cookies and you won't see this message again. If you click 'Reject all non-essential cookies' only necessary cookies providing core functionality such as security, network management, and accessibility will be enabled. Click 'Find out more' for information on how to change your cookie settings.

In this paper we report a novel method, based on co-axial electrohydrodynamic jetting, for the preparation of microbubble suspensions containing bubbles <10 microm in size and having a narrow size distribution. No selective filtration is necessary and the suspensions are produced directly by the process. To demonstrate the method, glycerol was used as the liquid medium, flowing in the outer needle of the co-axial twin needle arrangement and undergoing electrohydrodynamic atomization in the stable cone-jet mode while air flowed through the inner needle at the same time. At zero applied voltage a hollow stream of liquid flowed from the outer needle. When the applied voltage was increased, eventually the hollow stream became a stable cone-jet and emitted a microthread of bubbles, which were collected in a container of glycerol to obtain microbubble suspensions. The size of the microbubbles was measured via optical microscopy and laser diffractometry. Several microbubble suspensions were prepared and characterised and the size distribution was found to be critically dependent on the ratio (n) of flow rates of liquid/air and, in particular the flow rate of the air. At n=1.5, with the flow rate of air set at approximately 1.7 microl/s, a microbubble suspension containing bubbles in the size range 2-8 microm was obtained.

Original publication

DOI

10.1016/j.medengphy.2006.08.009

Type

Journal article

Journal

Med eng phys

Publication Date

09/2007

Volume

29

Pages

749 - 754

Keywords

Colloids, Electrochemistry, Equipment Design, Equipment Failure Analysis, Gases, Microbubbles, Microfluidics, Needles, Particle Size, Water